Loctite® 1919325 Epoxy Metal/Concrete, 0.85 Oz

Loctite® Epoxy Metal/Concrete is a two-part system consisting of an epoxy resin and a hardener. The convenient syringe dispenses equal amounts of each component every time. When mixed in equal volumes, resin and hardener react to produce a tough, rigid, high strength bond in 5 to 12 minutes. It is used as an adhesive for repairing, filling and rebuilding all metal and concrete surfaces.

• 0.85 Oz
• High impact resistance
• Will not crack when drilled
• Water resistant
• Great for interior or exterior projects
• Will not shrink
• One-time application
• Convenient double syringe
• Dispenses equal amounts of each component every time
• Will not conduct electricity
• Can be used for sealing electrical components
• Sets in 5 to 12 minutes
• Quick completion of project.

Recommended For:

• Bonding metal and concrete as well as glass, ceramic and wood
• Repairing machinery, appliances, tools, lawnmowers, automotive components, pipes, embedding bolts and screws into metals, concrete or stone and sealing electrical components against moisture and vibration.

Not Recommended For:

• Polyethylene, polypropylene, Nylon™, Teflon™ or flexible materials
• Applying at temperatures below 39°F (4°C) and above 95°F (35°C)
• Continuously wet areas or water immersion.

Directions:

Safety Precautions:

• Apply and cure in a well ventilated area. Wear gloves and wash hands after use.

Preparation:

• Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces for better adhesion. Pre-fit parts to be joined. Remove the plug from between the piston. Cut off the end tips of the syringe. Turn syringe end up and pull plunger back slightly allowing air bubbles to rise to top. Depress the double piston to dispense equal parts of the two materials on a disposable surface. Mix resin and hardener thoroughly until uniform in color. Wipe syringe tips clean, retract piston slightly and close with the plug. Ensure that the plug is always placed in the same orientation on the tips.

Application:

• Apply a small amount to both surfaces, join and press together. Remove any excess glue immediately with acetone. Support until bond sets in 5 to 12 minutes at room temperature. Usable strength in 12 hours. Full cure and strength in 24 hours.

Cleanup:

• Clean excess glue immediately with acetone before adhesive sets. Cured adhesive may be cut away with caution using a sharp blade. Prolonged immersion in paint stripper will soften the cured adhesive to aid removal. Use an approved hazardous waste facility for disposal.

Additional Info:

• Loctite® Epoxy Metal / Concrete does not conduct electricity which is ideal for sealing electrical components. It cures to a metallic gray finish and can be easily sanded or machined. It does not shrink and is resistant to water and most common solvents.